The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
50 Posts
Discussion Starter #1
Trying to pull apart the knife drive/wobble box can anyone point me to an exploded view to show me what i will find besides a stuffed bearing. can the bearings be replaced or is it cheaper to get a new one. I'm having a fair bit of difficulty getting the flywheel? off the top. maybe i'm going in from the wrong end???
 

·
Premium Member
Joined
·
5,739 Posts
If you go onto the New Holland website and then into the parts and look up a 994 or 94C header, it should be there. It is diagram number 4.40 in the 94C. That might help. I've never had one apart, but might give you a start.
 

·
Registered
Joined
·
1,113 Posts
I haven't had one apart ,there are very few parts inside ,bearings are not too expensive ,if you need a crown wheel and pinion and a rotor you can shoot $1000 fast a new drive is $3000 or more.
 
1 - 3 of 3 Posts
Top