The Combine Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
110 Posts
FarmerJones would you pls send me your "flow chart". I have replaced armrest circuit boards and also switches but am still having problems getting the seperator to engage on the first flip of the switch. Also now the head will not start at all. Addresses show the switches to be working and the safty seat switch also checks ok. Changed the little electric piece on the outside of the clutch. Sometimes have two low speed lights flash when you engage the header and a short beep, sometimes a few more lights and a beep? Had 1 acre to cut when the head just quit running. Then naturally the rain came about half hour later. Still setting in the middle of a big city with one stinkin acre. Hopefully get it goin tomorrow and get outa the 15 acre patch in the city! Thanks in advance!
Have a good one,
DeereCattopher
 

· Registered
Joined
·
110 Posts
Ended up being a bad switch here to! The address for the switch showed it was working, but when the d-tac man went to another address it showed the switch dropping to only 9 volts at times and kicking out. Then would not fire back up till it happened to to hit 12 volts again. Something so simple yet so frustrating. Glad your going again farmerboy, and thanks for the help and information from everyone else.
Have a good one,
DeereCattopher
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top