The Combine Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
80 Posts
Discussion Starter · #1 ·
On a 9550 the separator will stop every now and again while combining. Most of the time when you go to engage it it it will engage for a sec. or two and than stop. It takes 2 to three times to get it too stay running. Some times it won't engage at all and you have to flip it a couple times. I pretty sure its the switch, dealer didn't have one. It wouldn't be the solenoid on the gear case would it. It just started doing this to day. Do you have to take the arm rest apart to replace switch. I pulled the switch out but couldn't find the end of the wire.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top