The Combine Forum banner

Setting a NH TR98 for small grains

3056 Views 1 Reply 2 Participants Last post by  fordboy
Need some help with my TR98 on setting it up. The manual is not too clear or I just dont follow it on setting the diverter plates etc. Alot different from my old TR75. The concave settings should be the same from the 75 to the 98. On oats and barley I had my concave at 7, fan 800rpm, and rotors 1100rpm. Wheat and canola are going to be a set as I go I think, have not combined either with a TR before.

This is the left (looking from the back)

This is the right side.

What holes should these pins be in?
See less See more
1 - 1 of 2 Posts
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.