The Combine Forum banner
1 - 1 of 3 Posts

· Registered
117 Posts
if I am hearing your problem right if it`s the front arm that bolts to the eccentric they normally have one washer where it bolts to the shoe. If I take one apart that has none I usually put one on each side when putting back together. do not put 3 on one bolt. the arm should be snug against the channel or the cast support depending on what you have. you could get by taking a shim out to get your cotter in but thats it. make sure that your arms are centered when all together (shaker arms that support sieves) good luck
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.