The Combine Forum banner
1 - 1 of 3 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I am reinstalling shaker arms after replacing the bushings. I put them back together according to a reinstall guide from the dealer and when finished I found 3 extra washers on the front drive. In the diagram it didn't have any washers where the arm bolts to the shoe. So I reinstalled with the 3 washers there, but now I can't get all the washers on the pin where the cotter pin goes, nor does it look tight against the frame. Should I take a washer out of the bottom or just not use all at the cotter pin. Thanks for any help
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.