The Combine Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
1,098 Posts
Discussion Starter · #1 ·
hey all,

we have a rather early Shelbourne Reynolds 20 foot stripper header (still has the belt between the rotor and the auger), and have interest on putting it on our 80 N5 Gleaner with the 82+ feeder house.

our faceplate is currently a john deere, and we have located a Gleaner plate off a Shelbourne CVS header.

Will the CVS faceplate fit the older shelbournes?

any input appreciated, thanks!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top