The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
We are currently working in the canola and my sieve sensitivity will not stop beeping at me! It is in the red all the time and set to 30.

I am running my settings at the following
Fan 700
Upper sieve 6
Lower sieve 9
Rotor 590
Concave 27
Spinners 480

What am I doing so wrong? Feeling confused and frustrated with this canola! Is it all flying out the back!
 

·
Registered
Joined
·
1,851 Posts
Your settings are very similar to ours. Although i would run my seives a bit more open. Verify that your losses are in check and set your sieve sensitivity. For canola we typically have ours around 15 sensitivity. But it meaningless if it's all going out the back. So set it for minimal losses and then adjust your loss sensitivity.
 

·
Registered
Joined
·
2,196 Posts
Could be overload seive, do a kill stall and check to see how much material is on the seives... Might need rotor covers and chopper covers to help prevent over loading

Rotor seams fast, 55orpmand fan not over 600 I found works good
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top