The Combine Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,105 Posts
Discussion Starter · #1 ·
The right arrow button on my smartrax II controller in my Miller 4365 has quit working making it impossible to use autosteer because I can't agree to the terms and conditions on startup.

Farmtronics said it would have to be sent away at an unknown cost and 3 to 6 weeks to get it fixed.

Anyone have suggestions on how to get it by?
 

Attachments

·
Registered
Joined
·
1,105 Posts
Discussion Starter · #4 ·
Farmtronics are funny.


Just needs to be re-traced.

Also, you can access a virtual panel from your Viper Pro, if that's what you're using....
I'm thinking it just needs the pad replaced. I'm sure I've damaged it by now.


Yes, it's a Viper Pro. How can I access the virtual panel?
 

·
Registered
Joined
·
1,105 Posts
Discussion Starter · #6 ·
On startup, where you have the menu for starting viper going to windows desktop, etc there should be an option of memory serves.
I fix lots of those pads. Half the time it needs the front cover pulled off (four screws) and the ribbon unplugged and plugged back in. The other half the time the wire is broken and it is repaired by retracing the lines.
That’s what agexpress does too which is where Farmtronics would send it.
The button no longer clicks when it's pressed now so I'm guessing it's actually in need of a new front pad, now. The connections seemed good. Could still be a broken wire.
 
1 - 3 of 3 Posts
Top