The Combine Forum banner
1 - 1 of 1 Posts

· Registered
3,259 Posts
Discussion Starter · #1 ·
Hi all. I've been looking for a picture of the ST rice rotor but with no luck. Does anyone have a picture they would share?

Also I need to find the leading ramp angle on the rasp bars for it and the material transport ramp angle on the rearward to the machine side of the rasp bar. I realize those are probably not the correct engineering terms for the angles, but its the best I can come up with right now.

I'm looking at figuring out if I can use this rotor in grass seed. I believe it was tested in grass, but the results I have'nt heard other than bad rumors so,.............

Thanks for any info or pics.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.