The Combine Forum banner
1 - 3 of 3 Posts

Premium Member
256 Posts
Discussion Starter · #1 ·
There is a gap above the pipe the concaves pivot on. Looking thru it I can see the threshing elements on the rotor. There is another gap at the front end of this pipe.

Deere claims no unthreshed grain can come thru these gaps. I can't believe this.

Any comments will be appreciated.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.