The Combine Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
Going to install the PF discharge beater right away. How do you go about it? Does the shaft slide out easy through the inside hubs on the old one? How to go about lifting the new one in, it's heavy! Remove any tin above it?

Any tips would be much appreciated.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top