The Combine Forum banner
1 - 1 of 1 Posts

· Registered
22 Posts
Discussion Starter · #1 ·
Some knowledge on the Rotor drive and efficiency

You have 3 manual settings

Range 1.220-450rpm (In the ops manual)
At approx the mid point off all the three ranges you have the engine providing the drive.
In all ranges it is better to speed up and run higher from that mid point rpm.
The hydraulic system will use more available power if you go below the midpoint in all three ranges.When you plug your rotor that same hydraulic motor that allows the machine that de slug capability gives the machine variable rotor rpm.
BE 100% SURE you got it in the detent if you have to shift gears in the rotor gearbox.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.