The Combine Forum banner

Tire repair

1680 Views 2 Replies 3 Participants Last post by  CDN
I ran over a metal feed bunk that was hiding in the weeds with the front tire of our 4440. It has new 4 rib tires on the front and I sliced the inside rib all the way through and into the body of the tire, but not into the cords. Is there anything that can be done to keep the flap attached or prevent it from tearing farther?

1 - 1 of 3 Posts
You can get it vulkinsed if I spelled that right. They cut a piece out and put in a rubber compound and heat the spot and it bonds it just about like new. Had it done on a loader tractor and never had any problems
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.