The Combine Forum banner
1 - 4 of 4 Posts

· Premium Member
Joined
·
225 Posts
Discussion Starter · #1 ·
It was only -32 here today with wind chill. Was feeding this morning and hydraulics were getting slower and slower do to wind chill and loader quit raising and next grapple quit closing. Put the tractor in shop all day still won't work properly. Loader will raise once and will go down but won't come back up. Grapple will close once or twice then will open but not close. If tractor is off for awhile the sequence starts all over again. Any ideas?
 

· Registered
Joined
·
278 Posts
Does the three point seem to function properly? Have you tried switching to a different set of remotes? Watch for spool valve movement at the remote as you move controls. Agree about trying filters first, but should be a light on if its them. Could be something in the valves, do the flow control adjustments operate properly?
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top