The Combine Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
140 Posts
Discussion Starter #1
I thought at the update school they said a 7010 with the ver 21 software would have the concave #'s in mm like the 7120. I zeroed the concave, which was open an inch at the closed stops or 0. Getting ready for sbeans and set to 20 (I thought mm) & go back and check & concaves are wide open. Did ver 21 not get installed right? tia
Dana
 

·
Registered
Joined
·
93 Posts
make sure that the ccm s got updated as well and it should have switched over to what you are talking about
 
1 - 2 of 2 Posts
Top