The Combine Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey everybody, I keep getting the diagnostic light flashing on a JD 9760. When I follow the directions in the book I can see its throwing the code C00 14, but not the complete 4 digit address. It doesn't come on all the time, only when the separator and header have been engaged for several minutes, everything is running fine, haven't noticed any problems but I would just like to know if anybody else has seen this before.
 

·
Registered
Joined
·
778 Posts
The diagnostic icon (wrench book) will flash whenever there is an active trouble code. Often they do not affect operation as is the case with your code now. Your code is not complete, though. There should be more, like C00 1437.19. If the code is truly active then as soon as you press the diagnostic button below the 2nd cornerpost display the full code will appear in the bottom display.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top