The Combine Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
warning lights stopped flashing on my 9600. I have looked thru the part catalog and have not found a flasher unit. Without a tech manual I am at a loss on how the system works. If it is similar to the truck, I would be looking for the flasher unit to replace. Any help is greatly appreciated.
 

·
Premium Member
Joined
·
1,236 Posts
The flasher unit is in the central electronics box outside of the cab door. It is built in the power distribution board, there is a relay that can be replaced, but the flasher unit you can not replace, if bad will have to replace the board. The flasher relay is makered, maybe change a good relay that you know works for that one to see if they work also check the circuit breaker. There is a long list of things to check, see if the other things make it work, if not i can try to tell you were to check for volts.
 

·
Registered
Joined
·
19 Posts
Discussion Starter #3
Thanks for the info. I thought the flasher unit was part of the electronic box. I will move the relays. I also found that the turn signals are inop, so I could have a circuit breaker open.
thanks again for your help
.
 
1 - 3 of 3 Posts
Top