The Combine Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
Does anyone know what pressure the charge pump on a honeybee grain belt plus 3055 should be? Having a problem with the knife, canvases, and auger all slowing down in tough spots but the system pressure does not increase, it just slows down untill it stops. If I block the flow it can make enough pressure to trip the 2800psi relief valves.

Thanks
 

·
Vendor
Joined
·
4 Posts
Does anyone know what pressure the charge pump on a honeybee grain belt plus 3055 should be? Having a problem with the knife, canvases, and auger all slowing down in tough spots but the system pressure does not increase, it just slows down untill it stops. If I block the flow it can make enough pressure to trip the 2800psi relief valves.

Thanks
Hi there. Try asking our network of ag experts for free on the AGvisorPRO app. Make The Best Decisions - AGvisorPRO
 

·
Registered
Joined
·
272 Posts
Talked to the inventor... Charge pump is about 150 psi. but the issue is most likely a loose pump swashplate control arm. must be TIGHT. newer designs are 1 inch plate. if it flutters when running, it will make the header do what you are describing.
 
1 - 4 of 4 Posts
Top