The Combine Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
I'got a 2000 R72 with single point hookup on it, and an 800 grain head with single point but the head does not have the electrical plug on it yet. I have the pins and the end to put in the block, but my question is where would I find a wiring diagram to know which wire goes in which hole??? My service book doesn't show it and I can't find it on the internet anywhere.Thanks.
Mike
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top