New to me 2014 Common Cab 8230 combine Is throwing a shorted to low source E-0071-41 Header Height Sens. R Code.
The combine throws the code without a head on when moving the feeder house up and down. It also does it when I put on a CaseIH 2162 Flex Draper for the first time.
I also got a code while I was working to calibrate the Draper that the auto header height was disabled.
i also had an alarm that went off saying to disengage chopper knives. This didn’t appear when I put the Draper on, but came on after working through the calibration of the hd.
I don’t see any cuts in the feeder house harness and I cleaned the connectors.
Where else can I look to diagnose this problem?
The combine throws the code without a head on when moving the feeder house up and down. It also does it when I put on a CaseIH 2162 Flex Draper for the first time.
I also got a code while I was working to calibrate the Draper that the auto header height was disabled.
i also had an alarm that went off saying to disengage chopper knives. This didn’t appear when I put the Draper on, but came on after working through the calibration of the hd.
I don’t see any cuts in the feeder house harness and I cleaned the connectors.
Where else can I look to diagnose this problem?
